Nissan Altima Owners Manual: Front manual seat adjustment (if so equipped

Forward and backward


Forward and backward

Pull the center of the bar up and hold it while you slide the seat forward or backward to the desired position. Release the bar to lock the seat in position.

Reclining


Reclining

To recline the seatback, pull the lever up and lean back. To bring the seatback forward, pull the lever up and lean your body forward. Release the lever to lock the seatback in position.

The reclining feature allows adjustment of the seatback for occupants of different sizes for added comfort and to help obtain proper seat belt fit. See Precautions on seat belt usage later in this section. Also, the seatback can be reclined to allow occupants to rest when the vehicle is stopped and the shift lever is in the P (Park) position.

Seat lifter (if so equipped for drivers


Seat lifter (if so equipped for drivers seat)

Pull up or push down the adjusting lever to adjust the seat height until the desired position is achieved.

    Seats
    WARNING ● Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against your body. In an accident, you could be thrown into i ...

    Front power seat adjustment (if so equipped for drivers seat)
    Operating tips WARNING Before driving the vehicle, return the seatback to an upright seating position after manually releasing it. Also, make sure the seat is locked in place. Failure to do so ...

    Other materials:

    Symptom diagnosis
    SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer' ...

    Service data and specifications (SDS)
    General Specification (Rear) Rear Wheel Alignment (Unladen*) *: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. *: Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. Ball ...

    AV Branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side). I ...