Nissan Altima Owners Manual: Locking with power door lock switch

Nissan Altima Owners Manual / Pre-driving checks and adjustments / Doors / Locking with power door lock switch

Door lock switch


Door lock switch

To lock all the doors without a key, push the door lock switch (driver’s or front passenger’s side) to the lock position 1 . When locking the door this way, be certain not to leave the key inside the vehicle.

To unlock all the doors without a key, push the door lock switch (driver’s or front passenger’s side) to the unlock position 2 .

Lockout protection

When the power door lock switch is moved to the lock position and any door is open, all doors will lock and unlock automatically. With the Intelligent Key left in the vehicle and any door is open, all doors will unlock automatically and a chime will sound after the door is closed.

These functions help to prevent the Intelligent Key from being accidentally locked inside the vehicle.

    Locking with inside lock knob
    Inside lock To lock the door without the key, move the inside lock knob to the lock position 1 , then close the door. To unlock the door without the key, move the inside lock knob to the unlo ...

    Automatic door locks
    ● All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h). ● All doors unlock automatically when the ignition is placed in the OFF position. The automatic unlock ...

    Other materials:

    Power steering oil pump
    QR25DE : Disassembly and Assembly The power steering oil pump and pulley is not serviceable and should be replaced as an assembly. For front and rear bracket removal, refer to ST-19, "QR25DE : Removal and Installation". VQ35DE : Disassembly and Assembly The power steering oil pump an ...

    P0710 CVT fluid temperature sensor
    Description The CVT fluid temperature sensor detects the CVT fluid temperature and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously per ...

    Cylinder head
    Removal and Installation 1. Cylinder head bolt 2. Cylinder head 3. Cylinder head gasket 4. Engine block A. Follow installation procedure REMOVAL 1. Remove the intake and exhaust camshafts. Refer to EM-177, "Removal and Installation". 2. Remove the coolant outlet housing. Refe ...