Nissan Altima Owners Manual: System features

NISSAN Voice Recognition can activate the following


NISSAN Voice Recognition can activate the following systems:

● Bluetooth Hands-Free Phone System ● Navigation
● Audio
● Information
● My Apps

For additional information on the navigation system, see the separate Navigation System Owner’s Manual.

How to say numbers

NISSAN Voice Recognition requires a certain way to speak numbers in voice commands. Refer to the following examples.

General rule: Either “zero” or “oh” can be used for “0”.

Phone numbers

Speak phone numbers according to the following example. For 1-800-662-6200, say dial number and then speak the phone number in any of the following formats:

● “one eight oh oh six six two six two oh oh” ● “one eight hundred six six two six two oh oh” ● “one eight zero zero six six two six two oh oh”

For the best voice recognition phone dialing results, say phone numbers as single digits. Also, full numbers can only be spoken for “800”. For example, you cannot say 555-6000 as “five five five six thousand”.

    Using the system
    Initialization When the ignition switch is in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the system is ready to accept voice commands. If ...

    Bluetooth® Hands-Free Phone System voice commands
    To access the Bluetooth® Hands-Free Phone System voice commands: 1. Press the button. 2. Say “Call” and then a name in the vehicle phonebook to call that entry. Otherwise, say “Phone” t ...

    Other materials:

    Rear-facing child restraint installation using the seat belts
    WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudde ...

    Reverse signal circuit
    Description A reverse signal is supplied from the back-up lamp relay to the rear view camera control unit. When this signal is received, the display shows a view to the rear of the vehicle. Diagnosis Procedure 1.BACK-UP LAMP INSPECTION 1. Turn ignition switch ON. 2. Shift selector lever t ...

    Front tweeter
    Removal and Installation REMOVAL 1. Remove the front pillar finisher. Refer to INT-20, "Removal and Installation" (coupe) and INT-42, "Removal and Installation" (sedan). 2. Remove tweeter speaker grille. Refer to IP-12, "Removal and Installation". 3. Remove ...