Nissan Altima 2007-2012 Service Manual: Component diagnosis

Diagnosis system (TCM)
CONSULT-III Function (TRANSMISSION) CONSULT-III can display each diagnostic item using the diagnostic test modes shown below. FUNCTION WORK SUPPORT MODE Display Item List Engine Brake Adju ...

U1000 CAn comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

Other materials:

P0447 evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the c ...

Vehicle security system
System Diagram System Description INPUT/OUTPUT SIGNAL CHART OPERATION FLOW SETTING THE VEHICLE SECURITY SYSTEM Initial Condition • Ignition switch is in OFF position. Disarmed Phase • When doors or trunk is open, the vehicle security system is set in the disarmed phase on the ass ...

Power supply and ground circuit (sedan)
AUDIO UNIT  Diagnosis Procedure 1.CHECK FUSES Check that the following fuses are not blown. Are the fuses OK? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. 2.POWER SUPPLY CIRCUIT CHECK 1. Disconnect audio u ...