Nissan Altima 2007-2012 Service Manual: On-vehicle repair

Compression pressure
CHECKING COMPRESSION PRESSURE 1. Warm up the engine to full operating temperature. 2. Release the fuel pressure. Refer to EC-550, "Inspection" (California), EC-1038, "Inspection&q ...

Air cleaner and air duct
Removal and Installation 1. Air duct hose 2. Front air duct 3. Air cleaner mounting bracket 4. Air cleaner assembly 5. Mass air flow sen A. To electric throttle control actuator REMOVAL 1. R ...

Other materials:

Rear bumper
Removal and Installation 1. Rear bumper side brackets 2. Rear bumper supports 3. Rear bumper reinforcement 4. Rear energy absorbing foam 5. Rear bumper fascia A. C205 push pin REMOVAL 1. Remove the LH and RH rear combination lamps. Refer to EXL-260, "Removal and Installation" ...

Multiport fuel injection system
System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM via the CAN communication line. *3: ECM determines the start signal status by the signals of engine speed an ...

Throttle valve closed position learning
 Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time the harness connector of electric throttle control actuator or ECM ...